产品介绍

粘粉是以建筑石膏为主要成分的粘结材料，适用广泛，如用来粘结纸面石膏板，衬垫龙骨或保温绝缘材料;粘结石膏线条;填补墙面开凿的管线槽;特殊接缝部位如石膏板与水泥墙阴角，可以用来填缝，也可用于内墙墙面找平，填补水泥墙上的细密裂纹。根据凝结时间的不同分为快干和慢干两种。

Bonding powder is a kind of bonding material mainly composed of building gypsum, which is widely used, such as paper gypsum board, lining keel or insulation material, bonding gypsum lines, filling pipe grooves cut on the wall, special joints such as gypsum board and shade corner of cement wall, can be used to fill seams, also can be used to leveling the inner wall and filling the fine cracks in the cement wall. According to the different setting time, it can be divided into fast drying and slow drying.

性能特点

直接用水调制，施工快捷，缩短工期;

无需加建筑胶水，无毒无味，绿色环保;

石膏基产品，干缩湿胀率小，不开裂，耐火性能好;

加入高达60%的胶合剂，附着力极强，粘结强度高;

适合于各种不同材料的基底

Direct water modulation, fast construction, shorten the construction period;

No need to add building glue, non-toxic, tasteless, green environm-ental protection;

Gypsum based products have small dry shrinkage and moisture expansion rate, no cracking and good fire resistance.

Adding up to 60% of the adhesive has strong adhesion and high bond strength.

A substrate suitable for a variety of different materials.

使用方法

一、快干粘粉(干燥时间：8分钟左右、15分钟左右)

1、粘接前先做表面处理，除去浮土疏松物及各种不利于粘接的物质

2、将粘粉倒入干净的容器内，加入水迅速调匀，

3、将调好的粉胶多处点涂被粘物背面，然后置于预定位置，用手按压粘合点，使被粘物稳定住，大的石膏装饰建议用金属挂件固定。

二、慢干粘粉(干燥时间：40-120分钟)

1、先做表面处理，除去浮土疏松物及各种不利于粘接的物质。

2、补缝或基底找平时，将粘粉搅拌均匀后，用抹灰刀均匀涂抹于基面上。一次批刮不易超过10mm。

一 Fast-drying sticky powder (drying time: 8 minutes or so, 15 minutes or so)

1. Surface treatment before bonding to remove loose floating soil and all kinds of substances which are not conducive to bonding.

2. Pour the sticky powder into a clean container and add water to mix quickly.

3. Put the prepared powder glue on the back of the sticky object at many points, then place it in a predetermined position, press the sticky point by hand to stabilize the sticky object. Large gypsum decoration is suggested to be fixed with metal hangings.

二 Slow-drying sticky powder (drying time: 40-120 minutes)

1. Make surface treatment first to remove loose floating soil and all kinds of materials which are not conducive to bonding.

2. After stirring the sticky powder evenly, apply the plastering knife evenly on the base surface. It is not easy to scrape more than 10 mm at a time.